If your device shows a Wi-Fi connection but websites won’t load, the problem is almost always between your router and your internet service provider (ISP), not your device. This guide walks through the most common causes and fixes, from a simple router restart to checking for ISP outages.
Why Does This Happen?
Your Wi-Fi connection and your internet connection are two separate things. Wi-Fi is the wireless link between your device and your router. Internet access is the link between your router and your ISP. You can have a strong Wi-Fi signal (full bars) while the router has lost its connection to the internet, or while the DNS (Domain Name System) that translates website names to IP addresses is down.
Other causes include:
- ISP outage in your area
- Faulty modem or router hardware
- Outdated router firmware
- Incorrect DNS settings on your device or router
- IP address conflicts
- VPN or proxy software interfering
- Router has too many connected devices and has run out of IP addresses
Quick Fixes to Try First
Start with these simple steps—they resolve a large percentage of cases.
- Restart your modem and router. Unplug both, wait 30 seconds, plug the modem back in, wait for it to fully boot, then plug in the router. This resets the connection and often clears IP address glitches.
- Test with another device. If only one device fails, the problem is on that device. If all devices fail, the problem is the router or ISP.
- Check for an ISP outage. Call your ISP’s customer service line or check their status page. Outages are common and usually resolved within hours.
- Forget and reconnect to the Wi-Fi network. On your device, go to Wi-Fi settings, tap the network, choose “Forget,” then reconnect by entering the password again.
- Renew your IP address. On Windows, open Command Prompt and type
ipconfig /releasethenipconfig /renew. On Mac, go to System Settings > Network > Wi-Fi > Details > TCP/IP > Renew DHCP Lease.
Router and Modem Checks
If the quick fixes don’t work, look at the lights on your modem and router. A solid green or blue light usually means a good connection; a red or blinking orange light often indicates a problem. If the modem’s “Internet” or “WAN” light is off or red, the modem isn’t connecting to your ISP. Try:
- Checking all cables are firmly connected (power, coax or phone line to modem, Ethernet between modem and router).
- Replacing damaged Ethernet cables.
- Logging into your router’s admin page (usually 192.168.1.1 or 192.168.0.1) and checking the WAN status. If it shows “Disconnected,” the router can’t get an IP from your modem.
- Updating the router’s firmware from the admin page—outdated firmware can cause intermittent internet loss.
DNS Settings and IP Conflicts
Sometimes Wi-Fi works but the internet doesn’t because DNS is failing. DNS converts domain names like example.com into IP addresses. If your ISP’s DNS server is down, you can switch to a public DNS like Google (8.8.8.8 and 8.8.4.4) or Cloudflare (1.1.1.1).
To change DNS on Windows: go to Network Settings > Change adapter options > right-click your Wi-Fi adapter > Properties > Internet Protocol Version 4 (TCP/IPv4) > Properties > Use the following DNS server addresses, and enter 8.8.8.8 and 8.8.4.4. On Mac: System Settings > Network > Wi-Fi > Details > DNS > add those addresses.
An IP address conflict happens when two devices on the same network get the same IP. This can block internet access. To fix, restart your router—it will reassign IPs. If the problem persists, check your router’s DHCP settings and ensure the IP pool is large enough for your number of devices.
When the Problem Is Your Device
If only one device is affected, try these device-specific fixes:
- Disable and re-enable Wi-Fi on the device.
- Turn off VPN or proxy software—these can route traffic through a broken server.
- Check date and time settings—if they’re wrong, some security protocols fail.
- Run the built-in network troubleshooter (Windows: Settings > System > Troubleshoot > Other troubleshooters > Network Adapter; Mac: System Settings > Network > Troubleshoot).
- Update the device’s network drivers or operating system.
Advanced Steps
If nothing else works, try the following:
- Reset your router to factory settings. Use a paperclip to press the reset button on the back for 10 seconds. You’ll need to reconfigure your network name and password.
- Check for MAC address filtering. If your router has MAC filtering enabled, it may block your device. Remove the filter or add your device’s MAC address.
- Test a direct Ethernet connection. Plug a computer directly into the modem. If the internet works there, the problem is your router. If not, the problem is the modem or ISP.
- Contact your ISP. If you’ve tried everything, the issue may be on their end—like a faulty line or a need for a technician visit.
Frequently Asked Questions
Why does my phone say “Wi-Fi connected” but no internet?
This usually means your phone has a valid IP address from the router, but the router itself can’t reach the internet. Try restarting your router and modem, and check if other devices work. If they do, the problem is your phone’s DNS or IP settings—try forgetting the network and reconnecting.
Can a VPN cause no internet even when Wi-Fi is connected?
Yes. A VPN routes your traffic through a remote server, and if that server is down or your VPN subscription has expired, you’ll have no internet. Disable the VPN temporarily to test. If the internet works without it, check your VPN settings or reinstall the app.
Why does my laptop connect to Wi-Fi but not to the internet, while my phone works?
If your phone works, the router and ISP are fine. The issue is likely on your laptop—outdated drivers, DNS cache, or a misconfigured proxy. Run the network troubleshooter, flush DNS (type ipconfig /flushdns in Command Prompt), and check if a proxy is enabled in your browser settings.
How do I know if my router is the problem?
Connect a computer directly to the modem with an Ethernet cable. If the internet works, the router is at fault. If it doesn’t, the problem is the modem or ISP. You can also log into your router’s admin page and look at the WAN status—if it says “disconnected,” the router isn’t receiving a signal from the modem.
Is it safe to use public DNS like 8.8.8.8?
Yes. Google and Cloudflare public DNS are widely used, reliable, and generally faster than many ISP DNS servers. They don’t block content or track your browsing in a way that affects you, and they can resolve DNS issues that your ISP’s server might have.
Why does my internet work after restarting the router but then stops again?
This often indicates an overheating router, outdated firmware, or a failing modem. Check if the router is well-ventilated and update its firmware. If the problem persists, contact your ISP—they may need to replace the modem or check the line for signal issues.
Related
Method: the standard formula for this calculation, rounded as each result states. See how the calculators work or report an error.
More cards in this drawer
- Credential Manager: Seamless Sign-In Explained
- API Governance for Public Data: What Growing Portfolios Need
- Samsung Smart Speaker Rollable Display: Facts
- HP 9730e: Wide Prints, Not A3 Scans
- What 8888 Does When You Use It as DNS Server
- Enterprise AI Hidden Cost: Data Architecture ROI